Deburring two sides In One Pass

Haeger SBM – S for Deburr and Edge Rounding

With this new machine you will deburr both sides
of the sheet at one time Creating no sharp
edges that may need to be hammered.

Completely deburr and round the edges on
internal and external edges.

The unique system used will offer long and even wear of consumables. Creating a very cost and time effective process.

Since only the edges are deburred the surface is not damaged, this means there is very little environmental waste.

Two sides in one pass, low environmental impact, much quieter than tradional methods means a much safer work place for your employees.

Features:

Deburr and edge rounding two sides in one pass
No need to turn sheet over.
Deburr all internal and external edges.
Dry operation - no removal of water or rust       required.
Deburr sheets protected with film without damage    of film
No damage to material surfaces
60% faster than traditional methods
   Consistent high quality edges

Features:

Reliable, one step oxide removal on all edges of    laser-treated sheets and plates up to ½ inch thick.
Rounding of all sharp edges.
Improved surface quality due to removal of rust,    scale and dirt.
Dry operation - no removal of water or rust    required.
Clean material for painting and powder coating.
Better quality of the sheet metal

Oxide Removal two sides
In One Pass

Haeger SBM – B for Oxide Removal

This revolutionary new machine can remove oxide from both sides of your laser cut parts in just one pass.

You will easily meet the demands of your toughest painting demands.

All parts up to 60” wide and 5/8” thick can be easily done on one machine.

The unique design of the counter rotating brushes means long lasting even wearing consumables.

The largest machine can process parts up to 4500 square feet per hour. The parts come out clean, free of scale, loose particles and rust and you get the additional benefit of breaking the sharp laser edges.

No more hand grinding, each part will be consistent and easily handled by one operator.

With this simple oxide removal process, you can use more oxygen to even faster and produce more parts with confidence. You increased productivity will mean increased revenues.