With this new machine you will deburr both sides of the sheet at one time Creating no sharp edges that may need to be hammered.

Completely deburr and round the edges on internal and external edges.

The unique system used will offer long and even wear of consumables. Creating a very cost and time effective process.

Since only the edges are deburred the surface is not damaged, this means there is very little environmental waste.

Two sides in one pass, low environmental impact, much quieter than tradional methods means a much safer work place for your employees.

• Deburr and edge rounding two sides in one pass
• No need to turn sheet over.
• Deburr all internal and external edges.
• Dry operation - no removal of water or rust required.
• Deburr sheets protected with film without damage of film
• No damage to material surfaces
• 60% faster than traditional methods
• Consistent high quality edges

This revolutionary new machine can remove oxide from both sides of your laser cut parts in just one pass.

You will easily meet the demands of your toughest painting demands.

All parts up to 60” wide and 5/8” thick can be easily done on one machine.

The unique design of the counter rotating brushes means long lasting even wearing consumables.

The largest machine can process parts up to 4500 square feet per hour. The parts come out clean, free of scale, loose particles and rust and you get the additional benefit of breaking the sharp laser edges.

No more hand grinding, each part will be consistent and easily handled by one operator.

With this simple oxide removal process, you can use more oxygen to even faster and produce more parts with confidence.

You increased productivity will mean increased revenues.

• Reliable, one step oxide removal on all edges of laser-treated sheets and plates up to ½ inch thick.
• Rounding of all sharp edges.
• Improved surface quality due to removal of rust, scale and dirt.
• Dry operation — no removal of water or rust required.
• Clean material for painting and powder coating.
• Better quality of the sheet metal